How to Flush a Jacksonville Water Heater

Posted by on Jan 17, 2014 in Water Heater Repair Jacksonville

Ok, so it is not an attractive water heater upkeep job, however it does require a little cleaning up from time to time. Yes, today Water Heater Repair Jacksonville is going to instruct one on the best ways to flush out a water heater. Some suggest doing this as soon as every one to 3 years, we feel it is best to do so as soon as a year. Doing this is not a tough or time consuming project – heck, let the kids aid even.

Why Flush a Jacksonville Water Heater?

If it is last the recommended life span of the system, it must have some sort of regular flushing done. Doing this will obviously assistant in having it run as efficiently as possible, which likewise implies conserving money on the expenditure of running the darn thing. That alone ought to be a great enough reason we feel!

In terms of water heater maintenance, flushing it will get free of the buildup of mineral deposits that natural occurs inside the water tank. If one has ever had loud sounds, popping, gurgling, mini-explosion noises, that is a sign that there is too much sediment inside the tank. This flushing procedure will help make certain that the tank heats up water far more quietly.

Step 1. If it is an electric water heater, turn the power off in the primary electric breaker box and turn the cold water supply off. If it is a gas heater, it is ok to leave the gas on – just turn the water off. Though, turn the thermostat setting dial to the pilot setting (make a note to remember what it was originally set at though for later on). Then, whichever faucet the water heater supplies is closest needs to be opened. This is usually easier than opening the pressure relief valve, however one can do that instead.Water Heater Repair Jacksonville

Step 2. At the bottom of the water heater is a drain valve that a garden watering hose can be attached to. There might be a cover over it depending on the brand. Think about turning the heat to the pilot setting a number of hours prior to flushing it if one desires so the water isn’t going to be as hot when it is drained. If that is not an option that’s fine, just make certain the garden hose used is in good condition to hold up against the greater temperature water.

Run the hose outside far from your house or if the water has cooled, one can drain the tank into containers.

Step 3. Open the water heater’s drain valve and start draining the water. For whatever reason the drain valve is normally made of plastic, so if one has an older water heater (and one that has not been drained since before time began) it may stick a little. Just beware to not break the plastic (which is why it would be good if the darn thing was NOT made from plastic).Water Heater Repair Jacksonville FL

Once the drain valve is open, also open the pressure relief valve on the heater. Water will (a minimum of it needs to if it pressure relief valve is working effectively) flow some from it. Attempt to let is flow steady and not too fast so it stirs up the sediment in the water heater. We want the sediment to drain out the bottom through the hose.

If draining in a bucket, even if having the hose drain into a bucket outside of the garage or basement where the water heater is found, fill a bucket and let it sit to see if the water is clear or if there is sediment, which will generally look like sand in the bottom of the container. Simply keep draining it up until the water is clear.

Step 4. Close the drain on the bottom of the tank and close the pressure relief valve if it is still open.

Step 5. Turn the supply of water on once more to fill the tank. Once it is full again, slowing open the pressure relief valve again to get some excess air out of the tank. Then, open a hot water faucet in the home to get much more air out of the system.

Step 6. Let the hot water in the bathtub run till a complete stream is streaming out. Once that occurs, it is ok to turn the power back on if it is an electric water heater, or reset the temperature setting for a gas water heater. Clearly, turn the bathtub faucet off. In about 20 minutes, the hot water ought to be heated up again.

There you go! Water Heater Repair Jacksonville FL is here to respond to any concerns you may have. Next take a look at our short article on what to do if one has no hot water.

Enhanced by Zemanta